The Novilon Select Collection is a selection of natural looking textured vinyl flooring, in both wood and stone surface designs to enhance any residential interior design.
The Novilon Select Collection is a selection of natural looking textured vinyl flooring, in both wood and stone surface designs to enhance any residential interior design.
Swatch Name | Pattern Repeat | Laying Direction |
Antique Oak | 1000mm X 1000mm | Do not reverse |
Bleached Oak | 1000mm X 1000mm | Do not reverse |
Harvest Oak | 1000mm X 1000mm | Do not reverse |
Quarry | 1000mm X 1000mm | Do not reverse |
Rustic Oak | 1000mm X 1000mm | Do not reverse |
Travertine | 1000mm X 1000mm | Do not reverse |
Vogue | 1000mm X 1000mm | Do not reverse |
Novilon Select should be installed in accordance with manufacturer’s recommendations. Sub-floors must be smooth, hard, clean, and dry before laying commences. Uneven, solid or suspended timber floors may need preparation to meet the required standard. In case of direct to earth concrete, it is essential that a damp proof membrane is incorporated. Novilon Select must be allowed to relax for 24 hours in a uniform room temperature between 18°C and 27°C. All sub-floors must be tested for moisture content prior to installation. Note that moisture in the sub-floor will react adversely with the adhesive during the curing period. Recommended adhesive: FloorworX No. 62 acrylic adhesive. Weld all joints with Noviweld solvent weld. Correctly applied Noviweld solvent weld seals al the joins preventing the penetration of moisture and dirt. It is important to seal around wet areas, sealing around edges of a new floor, especially where there is an abundance of water e.g. around baths, basins, toilets and laundries.
Supply and fix 2.60mm thick x 2.0m wide Novilon Select sheeting, manufactured in accordance with EN 653 and laid in FloorworX No. 62 acrylic adhesive which has been spread using a trowel fitted with an A2 notched blade at a rate of between 5.5m2 and 6.5m2 per litre on a previously prepared Class 1 sub-floor in accordance with SANS 10070, using FloorworX Self Leveller when required, including all cutting and waste. The sheeting must be rolled in both directions with an articulated 68kg three-sectional roller immediately after it has been laid into the adhesive. Joins must be welded with Noviweld solvent weld, especially around water points such as baths, basis, toilets and laundries.
Note: Do not overlay Novilon Select sheeting over old cushion vinyl. If Novilon Select sheeting is laid over old, embossed cushion vinyl the sheeting may indent and the old pattern will start to show through eventually. This will detract from the appearance of the newly laid floors and will result in premature deterioration of the floor surface.
FloorworX offers a 5 year limited warranty, subject to our terms and conditions, against defective material provided that it is installed and maintained in accordance with our recommendations.
Please Note: This product is for indoor use ONLY.
STANDARD STORAGE PRACTICE
If an installation is large and material has to be stored on site, the following precautions should be taken:
– Storage area must be secure and away from other trades
– Storage area should be clean, dry and environmentally stable (18 ºC – 23ºC)
– Tiles should be stacked at a maximum of 5 boxes per stack on a smooth floor
– Sheeting rolls should stand upright
– No heavy material should be placed on top of rolls or stacked boxes
Please Note: Temperature variations, excess weight or an uneven floor surface will distort the floor material. For more information please contact the FloorworX Technical Department by sending your query to info@floorworx.co.za